NXP SemiconductorsMCIMX27ADSEEingebettete Systementwicklungsboards und -kits

The i.MX27 Application Development System (MCIMX27ADSE) is a development tool which is designed to run software applications designed for i.MX27 microcontroller unit. The MCIMX27ADSE includes a main board, an LCD display panel, a keypad, a NAND flash card, an image sensor, a TV encoder card, etc. It supports application software, target-board debugging or optional extra memory.

• i.MX27 Multimedia Application Processor
• Two clock-source crystals, 32.000 KHz and 26 MHz
• Power management & Audio IC (MC13783) included battery changing, 10bit ADC, buck switchers, boost switcher, regulators, amplifiers, CODEC, SSI audio bus, real time clock, SPI control bus, USB OTG transceiver & touchscreen interface
• Multi-ICE debug support
• Two 512Mbit DDR-SDRAM devices, configured as one 128MB, 32-bit device
• One 256Mbit Burst Flash with 128Mbit Pseudo Static RAM (PSRAM) memory device, configured as one 16MB flash with 8MB PSRAM, 16-bit device
• An single board system with connections for LCD display panel, Keypad and Image sensor.
• Complex Programmable Logic Device (CPLD) for reducing the glue logics
• Software readable board revisions
• Configuration and user definable DIP switches
• Two SD/MMC, MS memory card connectors
• PCMCIA & ATA Hard Disk Drive (HDD)
• Two RS-232 transceivers and DB9 connectors (one configured for DCE and one for DTE operation) supporting on-chip UART ports
• External UART with RS-232 transceiver and DB9 connector
• Infrared transceiver that conforms to Specification 1.4 of the Infrared Data Association
• USB Host (HS & FS), USB OTG (HS & HS) interface
• Separate LCD panel assembly that connects to the main board
• Separate keypad unit with 36 push button keys
• Separate CMOS Image Sensor Card
• A 3.5 mm headset jack, a 3.5 mm line out jack, a 3.5 mm line in jack, a 3.5 mm microphone jack and a 2.5 mm microphone and headset jack
• Cirrus Logic CS8900A-CQ3Z Ethernet controller (10BASE-T), with RJ-45 connector
• AMD AM79C874 NetPHY (10BASE-T & 100BASE-X), with RJ-45 connector
• Two 32 × 3-pin DIN expansion connectors with most i.MX27 I/O signals
• Variable resistor for emulation of a battery voltage level
• NAND Flash card (Plugs into Main Board) which is included in the ADS kit
• LED indicators for power, Ethernet activity, and two LEDs for user defined status indication
• Universal power supply with 5 volt output @ 5 Amperes
• USB cable
• RS-232 serial cable
• Two RJ-45 Ethernet cables, network, and crossover